Luxman L-590AX User Manual

INTEGRATED AMPLIFIER L-590AX
21
Specifications
Continuous power output 30 W + 30 W (8 )
60 W + 60 W (4 )
Total harmonic distortion 0.005% (8 , 1 kHz both channels simultaneous drive, line straight on)
0.02% (8 , 20 Hz to 20 kHz both channels simultaneous drive, line straight on)
Pre-amplifier
Input sensitivity/input impedance
PHONO (MM) : 2.5 mV / 47 k
PHONO (MC) : 0.3 mV / 100 
LINE : 180 mV / 42 k
MONITOR : 180 mV / 42 k
BAL. LINE : 180 mV / 79 k
Main-amplifier
Input sensitivity/input impedance
MAIN-IN : 550 mV / 51 k
Output voltage REC OUT : 180 mV
PRE-OUT : 1 V
S/N ratio PHONO (MM) : 91 dB or more
(IHF-A weighted, 5 mV input, line straight on)
PHONO (MC) : 75 dB or more
(IHF-A weighted, 0.5 mV input, line straight on)
LINE : 107 dB or more
(IHF-A weighted, input shorted, line straight on)
Frequency response PHONO (MM) : 20 Hz to 20,000 Hz (±0.5 dB, line straight on)
PHONO (MC) : 20 Hz to 20,000 Hz (±0.5 dB, line straight on)
LINE : 20 Hz to 100,000 Hz (within – 3 dB, line straight on)
Tone control Max. amount of change BASS : ±8 dB at 100 Hz
TREBLE : ±8 dB at 10 kHz
Loudness control 100 Hz : +7 dB
10 kHz : +5 dB
Damping factor : 240
Accessories · Remote control RA-17 · Power cable
· Owner’s Manual · Safety cautions
· size “AAA” batteries (2)
Power supply voltage 230 V
〜
(50 Hz)
Power consumption 310 W
0.5 W (at standby), 220 W (at no input)
Max. external dimensions 440 (W) × 193 (H) × 463 (D) mm
Weight 28.2kg (main unit only)
* Specifications and appearance are subject to change without notice.

Luxman L-590AX Specifications

General

Type	Integrated Amplifier
Output Power	30W + 30W (8Ω), 60W + 60W (4Ω)
Input Impedance	47kΩ (LINE)
Frequency Response	20Hz-20kHz (+0, -0.5dB)
Signal-to-Noise Ratio	105dB (LINE)
Dimensions	440 x 193 x 463 mm