19
Remote control
The remote control shall be aimed at the remote sensor of
this unit within the specified angle range shown in the illus-
tration when used.
Dry cell
[How to load batteries]
1. Put your finger on the battery cover claw on the rear of the
remote control, and slide the cover downward to open it.
2. Put 2 AAA batteries in the battery case as shown in the
illustration.
3. Close the battery cover.
* When the batteries start to lose power, the effective
distance becomes shorter or the unit does not function
even though the switch is pressed. In such a case, both of
the batteries shall be replaced with new ones at the same
time.
* If the remote control is not used for a long time, the
batteries shall be removed from the case.
30°30°
Effective distance: approx. 5 m
7. Subsonic switch (SUBSONIC)
Cuts ultra-low frequencies out of audible range to prevent
ultra-low range noise from adversely affecting audible range.
This function is significantly effective especially when a re-
cord is warped or a woofer is shaking owing to ultra-low
range vibration.
• Every pressing of this switch toggles the subsonic on and
off.
The subsonic indicator lights up when the subsonic
switch is on.
* When the line straight switch is set to on, this switch does
not function.
8. Loudness switch (LOUDNESS)
Psychoacoustically compensates the frequency character-
istics when the volume control is set to the center position
or lower.
This compensation allows listeners to complement human
listening characteristics when the sound volume is in the
low level.
• Every pressing of this switch toggles the loudness on and
off.
The loudness indicator lights up when the loudness
switch is on.
* When the line straight switch is set to on, this switch does
not function.
9. Line straight switch (LINE STRAIGHT)
Enhances the purity of the sound quality by bypassing the
balance control circuit, tone control circuit, or the like.
off : Line straight off/bypass off
on : Line straight on/bypass on
• Every pressing of this switch toggles the line straight on
and off.
The line straight indicator lights up when the line straight
switch is on.
10. CD/SACD player operation switch
(CD/SACD PLAYER)
This switch is used to control the corresponding CD/SACD
players.
As of October 2010, the corresponding CD/SACD players are
D-08, D-06, D-05, D-10, D-7, D-600, and D-700S.
11. Volume (VOLUME, i, o)
This button is used to adjust the sound volume. The sound
volume is lowered with o and raised with i.
(line straight
indicator off)
(line straight
indicator on)
To Next Page
Loading...
Need help?
General
