Luxman L-590AX User Manual

22
Before Asking for Repair Services
While the unit is used, an unusual phenomenon may be confused as a malfunction for a certain reason. Prior to asking us for repair
services, please check the table below and read the instruction manual for the subsidiary devices. If the cause of the malfunction
cannot be identified, please contact your dealer.
Problem Cause Solution
No power is supplied even
though the operation switch is
pressed.
· The power plug is disconnected from the
wall outlet, or it is not completely inserted.
· Insert the power plug in the wall outlet se- Insert the power plug in the wall outlet se-
curely.
· The power plug is disconnected from the
AC inlet, or it is not completely inserted.
· Insert the power plug in the AC inlet se- Insert the power plug in the AC inlet se-
curely.
No sound is generated. · The volume control is set to the minimum
level.
· Rotate the volume control clockwise to ad- Rotate the volume control clockwise to ad-
just the sound volume.
· The input selector is not set to the source to
be reproduced.
· Set the input selector to the source to be
reproduced.
· Cable connections are incomplete. · Make cable connections securely.
· The output level of the input device is set to
the minimum position.
· Adjust the output level.
· The separate switch is set to on. · Set the separate switch to off.
· The mute switch of the remote control is
set to on.
· Set the mute switch to off.
No sound is generated on one
side.
· The balance control is fully rotated. · The balance control shall be set to the cen- The balance control shall be set to the cen-
ter position under normal conditions.
· The connecting cable is not connected on
one side only.
· Make cable connections securely.
Humming sound (boon or zzz
noise) is generated.
· The ground side of the pin-plug cable has
no contact with the terminal.
· Make connections securely so that the
ground side of the pin-plug cable can be
connected.
· The ground wire of the record player is not
connected.
· Connect the ground wire of the record play-
er to the GND terminal.
· Connections or mounting conditions are in- Connections or mounting conditions are in-
complete between the cartridge and shell,
or between the shell and tone arm of the
record player.
· Connect (or mount) the cartridge, shell, and
tone arm securely.
No effect of tone control or bal-
ance control is observed.
· The line straight switch is set to on. · When tone control or balance control is used,
the line straight switch shall be set to off.
The subsonic, monaural or
loudness is not activated.
· The line straight switch is set to on. · When the subsonic, monaural or loudness
is used, the line straight switch shall be set
to off.
The lights of the power meters
are not turned on.
· The meter switch is set to off. · Set the meter switch of the remote control
to on.
The separate switch of the
remote control is not activated.
· To prevent incorrect operations, this unit is
designed to toggle the separate on/off by
holding down the separate switch approxi-
mately for approx. 1 second.
· Hold down the separate switch of the re-
mote control for approx. 1 second.

Luxman L-590AX Specifications

General

Type	Integrated Amplifier
Output Power	30W + 30W (8Ω), 60W + 60W (4Ω)
Input Impedance	47kΩ (LINE)
Frequency Response	20Hz-20kHz (+0, -0.5dB)
Signal-to-Noise Ratio	105dB (LINE)
Dimensions	440 x 193 x 463 mm