Receiver indicator light status
Operating mode Indicator status
Radiator paused
Indicator status
Radiator Heating up
Standby Off
Off
Comfort Steady green Steady red
Eco Flashing green Flashing red-green
Anti-frost Slow ashing green Slow ashing red-
green
Comfort -1°C (*) Double ashing green Double ashing
redgreen
Comfort -2°C (*) Double slow ashing
green
Double slow ashing
red-green
Pairing mode Flashing orange Flashing orange
Sensor fault or
Measured temp. > 35°C
Flashing red --
The RF receiver is tted with an independent regulation system which saves status information (start/standby) and tem-
perature set points to its memory. Storage of the last received setpoint ensures the temperature is still regulated even if
the transmitter is turned off or its batteries exhausted. Also note that during a power outage to the radiators, pairing does
not need to be reinitialized.
Important: If your receiver is turned off , your radiator will not receive any commands from the remote control.
STARTING THE SYSTEM
RECEIVER (THERMOSTAT)
Connect your appliance to the electricity supply. Press button «B» located on the receiver at the bottom of the ap-
pliance to start the radiator. Indicator light «A» is illuminated and you will hear 2 short «beep» sounds. Pressing button
«B» again will turn off your radiator and produce a long «beep» sound. Indicator light «A» goes out, and no communi-
cation with the remote control is possible.
4
EN
To Next Page
Loading...