SECTION 6 LYCOMING OPERATOR’S MANUAL
TROUBLE-SHOOTING IO-320 SERIES
TROUBLE PROBABLE CAUSE REMEDY
High Oil Temperature (Cont.) Low grade of oil Replace with oil conforming to
specifications.
Clogged oil lines or strainers Remove and clean oil strainers.
Excessive blow-by Usually caused by worn or stuck
rings.
Failing or failed bearings Examine sump for metal particles.
If found, overhaul of engine is
indicated.
Defective temperature gage Replace gage.
Excessive Oil Consumption Low grade of oil Fill tank with oil conforming to
specifications.
Failing or failed bearings Check sump for metal particles.
Worn piston rings Install new rings.
Incorrect installation of piston
rings
Install new rings.
Failure of rings to seat (new
nitrided cylinders)
Use mineral base oil. Climb to
cruise altitude at full power and
operate at 75% cruise power
setting until oil consumption
stabilizes.
6-4
To Next Page
Loading...
