B. Gear Inspection
(1) Examine the involutes of the gear teeth for pitting and excessive wear.
(2) If pit marks are found, discard the gear and replace it with a new one.
(3) Examine the bearing surfaces of all gears for deep scratches.
(4) Remove minor abrasions with a fine abrasive cloth.
C. Screwed Fitting Inspection
(1) Examine the condition of the threads on screwed fittings (threaded fastenings or plugs).
(2) Remove small nicks and burrs with a small file, fine abrasive cloth, or stone.
(3) If the part cannot be repaired by polishing it, discard it and replace it with a new one.
(4) If the part has too much distortion, galling, or mutilation (caused by over-tightening or
use of an incorrect tool) replace it.
To Next Page
Loading...
