EasyManua.ls Logo

Lyda 203E - Operation Procedures; Starting a Cold Engine

Lyda 203E
55 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32
OPERATION
WARNING
Indicates a potential hazard that could
result in serious injury or death.
WARNING
POTENTIAL HAZARD
Operating ATV without being familiar with
all controls.
WHAT CAN HAPPEN
Loss of control, which could cause an
accident or injury.
HOW TO AVOID THE HAZARD
Read this manual carefully. If you do not
understand and control or function, ask your
dealer.
Starting a cold engine
1. Set the parking brake.
2. Turn the fuel cock to “ON”
3. Turn the engine stop switch to “RUN”
4. Turn the main switch to “ON”
5. Shift the transmission gear to neutral.
6. Push down the choke lever to the end.
7. Complete close the throttle lever.
8. Push the start switch to crank the engine.
9. Pull up the chock lever to the middle
position (warming up position) until the
engine runs then release the start button,
If the engine fails to start, release the start
button, then push it again. Each cranking
should not be more than 10 seconds.
10. Keep warming up the engine for 5min.
Then pull up the choke lever to top.

Table of Contents