49
Clutch adjustment
1. Remove the rubber cap.
2. Release the locknut.
3. Slowly turn the adjusting bolt clock wise until
resistance is felt. Then turn it 1/8 counter clock
wise.
4. Tighten the locknut to the specified torque.
5. equip the rubber cap safely.
Cable inspection and lubrication
Lubricate the inner cables and the cable ends.
If the cables do not operate evenly, ask your
dealer to replace them.
Knuckle shaft and steering shaft lubrication
Lubricate the pivot points. Use a grease gun.
Wheel removal
1. Raise the wheel by placing a suitable stand under
the frame.
2. Remove the nuts (or bolts for some models) from
the wheel.
3. Remove the wheel assembly
Wheel installation
When installing the wheel, reverse the removal
procedure.
Tighten the wheel nuts to the specified torques.
To Next Page
Loading...