Trouble removal
Please reinstall the 2-in-1 tank and start againCleaning will be triggered when the water tank is removed. Please reinstall the tank.
Please start the device on the level ground
Off the ground, please return to the ground
to start
Please check the crash barrierIf the collision sensor is stuck, please clean and maintain it.
Pick up the device, or the device is suspended in the air, please move the device to a flat
ground before starting.
Pick up the device, or the device is suspended in the air, please move the device to a flat
ground before starting.
Tilt the machine, move the machine to a level ground before starting.
If map data is lost, plan the path again．
Please move the main engine to open ground and restart.
Main wheel is stuck or entangled. Please check the main wheel and clean the foreign matter.
Main brush stuck or wrapped, please check the main brush and clean foreign matter.
If the edge brush is stuck or wrapped, please check the edge brush and clean the foreign matter.
Please restart away from the restricted area
Please put the machine flat on the ground
before starting
If the location fails, re-create the diagram
The machine is trapped
Please check the main wheel
Please check the main brush
Please check the edge brush
Please move the machine to a non-restricted area before starting up.
Prompt toneThe Solution
To Next Page
