EasyManuals Logo

Lynx 2000 5900 ST User Manual

Lynx 2000 5900 ST
Go to English
209 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #162 background imageLoading...
Page #162 background image
22
OPERATORS MANUAL
DRIVING
Important! Always check before starting:
· That the throttle and brake levers run smoothly and return to
basic position immediately after the grip is loosened.If not,
repair!
· That there is not ice or snow in the boggie, and that the track
has not frozen in the ground (lean the snowmobile).
· That all the covers are in there positions and the engine cover
is closed.
· Fasten the rope of the emergency switch on your right wrist or
to your clothing. At the same time check that the
emergency switch is not in short circuit.
· Check before driving that engine will stop when the emergency
switch is pulled off.
· Set the gear in neutral.
· Clean and check operation of the lights.
· Before driving check that the engine is stopped when the
emergency switch lock is pulled off.
STARTING THE COLD ENGINE
· Turn the ignition switch to on position turn until engine start.
· Pump with the primer 23 times.
· Turn the choke lever to upright position and further to max.
position.
· Pull smoothly the slack from the starter rope, and then pull
strongly. Return the rope by holding the handle. Faulty
proceeding may damage the starter.
· Turn the choke lever to upright position when the engine runs,
and turn the lever off when the engine has warmed up.
NOTE: If the engine is warm there is no need to use the primer. If
engine only ignites after two or three attempts, pump
once with the primer and start the engine.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lynx 2000 5900 ST and is the answer not in the manual?

Lynx 2000 5900 ST Specifications

General IconGeneral
BrandLynx
Model2000 5900 ST
CategorySnowmobiles
LanguageEnglish

Related product manuals