EasyManuals Logo

Lynx BRP REX2 49 RANGER 600HO E-TEC User Manual

Lynx BRP REX2 49 RANGER 600HO E-TEC
173 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #86 background imageLoading...
Page #86 background image
BASIC PROCEDURES
WARNING
Do not wind starting rope around
your hand. Hold rope by the han-
dle only. Do not start the snowmo-
bile by the drive pulley unless it is
atrueemergencysituation. Have
the snowmobile repaired as soon
as possible.
mmo2008-005-008_a
Attach one end of emergency rope to
rewind handle.
NOTE: The suspension adjustm ent
toolcanbeusedasanemergencyhan-
dle.
Attach the other end of emergency
rope to the starter clip supplied in the
tool kit.
mmo2008-005-009
Hook up clip on drive pulley.
mmo2008-005-012_a
1. Clip installation location
Wind the rope tightly around drive pul-
ley. When pulled, pulley must rotate
counterclockwise.
mmo2008-005-014_a
Pull the rope using a sharp, crisp pull so
the rope comes free of the drive pulley.
Start engine as per usual manual start-
ing.
WARNING
When starting the snowm obile
in an emergency situation, using
drive pulley, do not reinstall the
belt guard and return slowly to
have snowmobile repaired.
Vehicle Warm-Up
Before every ride, vehicle has to be
warme d up as follows.
1. Start engine as explained in
ENGINE
STARTING PROCEDURE
above.
_______________
83

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lynx BRP REX2 49 RANGER 600HO E-TEC and is the answer not in the manual?

Lynx BRP REX2 49 RANGER 600HO E-TEC Specifications

General IconGeneral
BrandLynx
ModelBRP REX2 49 RANGER 600HO E-TEC
CategorySnowmobiles
LanguageEnglish

Related product manuals