Lynx L24DWR User Manual

8
INSTALLING
IMPORTANT NOTE: If installing on a concrete floor,
concrete fasteners are required and not included with
the anti-tip kit.
CAUTION:
Any finished flooring should be protected with appropri-
ate material to avoid damage from moving the unit.
If unit has been laid on its back or sides, place unit up-
right and allow minimum of 24 hours before connecting
power.
1. Plug the unit into the 15 amp grounded GFI
outlet located in the installation opening. With power
applied to the unit, check that the lighting and cooling
function operate properly, then turn off power to the wall
outlet at the circuit breaker.
WARNING:
Shut off power to the wall outlet before installing into
the opening.
2. Check that the following are level and square:
 Front face and interior opening
 Installation opening and floor surface
 Countertop bottom front edge
IMPORTANT NOTE: Leveling legs should not be ex-
tend more than ¾” from bottom of the cabinet.
IMPORTANT NOTE: The floor under the unit must be
at the same level as the surrounding finished floor.
3. If all surfaces are level:
 Measure from the floor to the bottom of the front
edge of the countertop
 Measure the rear of the unit cabinet from the floor
to top of cabinet, at back corners
 Adjust rear legs so B measurement equals A meas-
urement. Using an adjustable wrench or pliers, turn
legs counterclockwise to raise the unit or clockwise
to lower the unit
4. Slide the unit into position, making sure the rear
cabinet leveling legs slide under the anti-tip devices.
Push the unit into the opening until the bottom front
edge of the cabinet is flush with the surrounding cabi-
netry or the leveling legs are tight with the anti-tip devic-
es.
IMPORTANT NOTE: The rear cabinet leveling legs must
be engaged under the anti-tip brackets.
5. Shim the front of the unit so the front face is flush
with surrounding cabinetry. Adjust the front legs to support
the countertop at the shimmed height. Using an adjustable
wrench or pliers, turn legs counterclockwise to raise the
unit or clockwise to lower the unit. Countertop should be
resting on top of the unit.
IMPORTANT NOTE: If countertop is not resting entirely
on unit top, shim the countertop to prevent damage to the
countertop.
CAUTION:
To prevent damage to the countertop and unit underneath,
do not place heavy objects on countertop directly above
the unit.
6. Re-install all drawers. Take extreme care to in-
sert sliding drawers squarely into slide brackets and prop-
er slide bracket grooves. When drawers are installed
properly a click should be heard from both slide bracket
retaining clips and should slide smoothly in the tracks.
When drawers are pulled out to full extension a stop is
activated to prevent additional pull-out.
CAUTION:
Improper drawer installation may not actuate slide stop
mechanism.

Lynx L24DWR Specifications

General

Brand	Lynx
Model	L24DWR
Category	Refrigerator
Language	English