SPECIAL NOTE FOR LP USE
Never connect any unregulated
gas supply to the grill. The hose
with regulator and Type 1 con-
nection included with your grill
has these safety features:
. The system will not allow gas to
flow until a positive connection
has been made.
.The system has a thermal ele-
ment that will shut-off the flow
of gas between 115 and 150°C
(240 and 300°F).
. The system has a flow limiting
device which, when activated,
will restrict the flow of gas to 10
cubic feet per hour.
NOTE: The cylinder control valve
must be turned off before any
connection is made or removed.
NEVER USE GRILL WITHOUT
FIRST LEAK TESTING THIS
CONNECTION, FOLLOWING
THE PROCEDURE ON PAGE 11.
Should the large, black, ther-
mally sensitive coupling nut be
exposed to temperatures above
115q50°C, it will soften, allow-
ing the regulator probe to dis-
engage from the cylinder valve,
thereby shutting off the flow of
gas. Should this occur, do not
attempt to reconnect the nut.
Remove the entire regulator as-
sembly and replace it with a new
one. The cause of the excessive
heat should be determined and
corrected before operating your
grill again. The regulator probe
also contains a flow-sensing el-
ement, which will limit the flow
of gas to the regulator to a man-
ageable amount in the event of
a hose or regulator rupture. If it
is evident that the flow control
device has activated, the cause
of the excess flow should be de-
termined and corrected before
using your grill again.
NOTE: Improper lighting proce-
dures can cause the flow control
to activate, resulting in reduced
heat output. If this is suspected,
to reset flow control, shut off
all burner controls and cylinder
valve, wait 30 seconds, then
turn cylinder valve on extremely
slowly, wait five (5) seconds and
turn burner valve on to light.
J L
l-
Figure 3-1- Theincludedhose
and regulator must be used ifyour
grill isset-up for an LP GasCylinder.
Wind hitting the grill while
in use, especially winds
blowing into or across
this hood gap,
Call cause poor
performance and
in some cases
can cause the
control panel
ous/y hot.
Figu re 3-2 - Steady or gusty winds can prevent the normal exhaust of hot gases. Locate your grill
away from prevailing winds and avoid grilfing in windy conditions.
@LYNX 3
To Next Page
Loading...
Need help?
General
