Lynx SEDONA - Assembly and Lighting Procedures; Step 1: Unpacking the Box; Step 2: Position and Level the Base

SEDONA by LYNX™ READY TO FINISH FIRE PIT ASSEMBLY INSTRUCTIONS
8 SEDONA by LYNX™ Ready to Finish Fire pit Assembly Instrucons
Step 1
Unpacking the Box
Remove the staples and binding straps from the outside of the box. From inside the box, remove the foam and
packing materials. Separate the re pit components from the box.
Step 2
Posion and Level the Base
Place the re pit base on a level surface in its nal locaon and proceed to verify
the re pit base is level it in all direcons. The boom panel has adjustable feet for
this purpose. DO NOT OMIT THIS STEP. If the base is not leveled correctly the re
pit will be misaligned.
Fire pit Base
(Level is not included)
Leveling Foot
Installaon