4
- Strong vibrations
• This drum contains digital circuitry and could cause interference if placed too close to radio or television
receivers. If interference occurs, move the drum further away from the affected equipment.
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules.
Also, this equipment has been tested and found to comply with the limits for the following standards:
EN550222006
EN55024:1998/+A1:2001/+A2:2003
EN55013:2001/+A1:2003/+A3:2006
EN55020:2007
EN6100032:2006
EN6100033:1995/+A1:2001/+A2:2003
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a different circuit from the circuit to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To Next Page
