30
SYSTEM/GROUP/CHANNEL SELECTION
System Selection
Several methods can be used to select a new
system.
METHOD 1: From knob: If system selection is
programmed to the SYSTEM/
GROUP/CHANNEL knob, select a
system by turning the SYSTEM/
GROUP/CHANNEL knob to the
desired system number position (1-
16). The display registers the new
system name on line one.
NOTE: The radio is supplied with a
mechanical stop which can, if desired,
limit the number of positions
accessed. If the knob will not access
all positions, do not force it.
METHOD 2: From keypad: If system selection is
programmed as the primary function
of < and >, select a system by
pressing <, or > to scroll
through the system list. The display
registers the new system name on line
one.
METHOD 3:
Direct Access: Press 1 to enter the
system select mode. Press the
numeric key which is mapped to the
desired system. Press M. The radio
will move to the selected system.
To Next Page
Loading...
