M-Audio code61 - Operation - Control Assignments and Modes; Fader, Button, Encoder Assignments

43
Faders
This chapter explains how to assign the faders to different commands. See the Editing
Assignments section to learn how to do this.
The faders’ functions also depend on their current mode. See the Modes section to learn
about their modes.
Editing Assignments
You can set the channel of each fader. See Channel to learn how to do this.
To learn how to assign different types of messages to a fader, see the Messages section.
Channel
To set the MIDI channel for a fader:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Move the desired fader. The fader’s number will appear in the display.
3. Press the Chan Assign key. The display will show CHN for 1 second and then show the
fader’s number and current MIDI channel or zone channel.
4. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired MIDI
channel (00 or 01–16) or zone channel (17–20).
Note: Values 00 and 01–16 correspond to Code 61’s global channel and the 16 available
MIDI channels. Values 17–20 correspond to channels used by Zones 1–4 (z1–z4).
5. Press the Enter key. The fader will be assigned to that channel, and you will exit Edit
Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.