63
Curve
The curve setting for an encoder determines its rate of acceleration as you turn it.
To set the encoder curve:
1. Press Edit to enter Edit Mode. The Edit button will light up.
2. Press the Curve key four times. The display will show ECrV and the current curve setting:
Display Curve
Number
Description
ECrVOf
00 Turning the encoder will always send a value change of one step
in either direction regardless of how quickly/slowly you turn it.
ECrVC2
01 This is a slow acceleration curve, useful for making fine
adjustments.
ECrVC3
02 This is a medium acceleration curve (the default).
ECrVC4
03 This is a quick acceleration curve, useful for making coarse
adjustments with broad “sweeps.”
3. Use the numeric keys (0–9) or Preset Down/Up () buttons to enter the desired curve
number (0–3).
4. Press the Enter key. The encoder will now use that curve, and you will exit Edit Mode.
To cancel your changes instead, press Edit. You will exit Edit Mode without saving anything.
Remember to store the preset if you want to save your changes in that preset.
To Next Page
Loading...
