4
8. Windows will identify the new USB Audio interface and will display a “Found New Hardware” Wizard like the one
seen below.
9. Choose “Install software automatically” and click “Next.”
10. Once the Wizard is completed, click “Finish.” Since there may be two components to the device driver installations that
must be installed for the USB Audio series interfaces (the “bootloader” and the driver itself), you may be presented
with another “Found New Hardware” Wizard. In this event, go back to step 10 and repeat the process.
11. Once the final “Found New Hardware” Wizard is complete, you will see a message pop up that says,“Your new
hardware is installed and ready to use.”
Installation Instructions For Mac OS X
PLEASE NOTE: do not connect your USB Audio series interface to your computer until the appropriate driver files have been
copied to your computer. Be sure to leave your USB audio device disconnected until instructed to connect it below.
1. Insert the USB Audio Driver CD-ROM into your computer’s CD-ROM drive.
2. Double-click the CD icon when it appears on your desktop to view the contents of the CD.
To Next Page
Loading...
Need help?
General
