34
Digital Performer Mode
To enter Digital Performer mode: Hold down the PAN button while powering on the unit. Digital Performer mode is confirmed on the LCD
display when the ProjectMix I/O has initialized.
IMPORTANT NOTE: The ProjectMix I/O has been tested with Digital Performer version 4.6. A few known control surface bugs have been
documented with earlier versions of Digital Performer, which may lead to erratic behavior. We strongly suggest upgrading to version 4.6;
earlier versions of the program are not fully supported.
Setup: With the ProjectMix I/O in Digital Performer mode, open your Mac’s Audio MIDI setup (found under the Utilities menu). Select the MIDI
Devices tab. Click on Add New Device and a new external device icon will appear. Double click on this icon to open its Properties page. Select
Mackie from the drop-down Manufacturers list, and Mackie Control from the Model list; Mackie Control will appear in the Device Name field.
Clicking on the Icon browser will allow you to select a mixer icon.
Click Apply. Now click the Less Information arrow twice to view the properties page, which will display the MIDI settings information.
Make your settings as shown in the screenshot below:
Digital Performer Mode
To Next Page
Loading...
Need help?
General
