42
You’ll start the control surface firmware updater by clicking OPTIONS in the upper-left corner of the ProjectMix Control window. Then click on
Update Firmware within the pop-up menu.
Once you select Update Firmware, the Firmware Updater will launch.
Before you click Update, take a look at the version number displayed in the title bar. If this number matches the ProjectMix I/O firmware
number that you wrote down above, then you do not need to run the Updater. If your ProjectMix I/O has an older version than the number
shown in the title bar, then you can proceed with the update.
To initiate the update, click the Update button and follow the on-screen directions. Once the firmware upload begins, a bar will slowly fill
from the left to right indicating the progress of the upload. Once the upload is complete, turn the ProjectMix I/O off, then back on. During
initialization, confirm that the new firmware version is shown in the LCD screen.
Using ProjectMix Control
To Next Page
Loading...
Need help?
General
