1. Terminal block
2. Rotary knob
1. Unpack the device.
2. Remove the packaging and cushioning material.
3. Install the device on a rail. For more information see Installation.
4. Download the grandMA3 onPC software on www.malighting.com.
5. Install the software on your PC or laptop. For minimum requirements see System Requirements grandMA3 in the grandMA3
user manual.
6. Start the grandMA3 console or grandMA3 onPC.
7. Connect the grandMA3 xPort Node DIN-Rail with your PC, laptop, or a grandMA3 console using the RJ45 connector.
Connect the grandMA3 xPort Node DIN-Rail with the electrical grid using a terminal block connector, a PoE switch, or a PoE
injector.
The device starts booting and the rotary knob starts flashing.
Important:
To configure a grandMA3 xPort Node DIN-Rail, use a grandMA3 console or the grandMA3 onPC software.
To turn off the grandMA3 xPort Node DIN-Rail, disconnect the RJ45 connector located on the back or the terminal block connector.
To Next Page
Loading...
