Hint:
grandMA3 xPort Node DIN-Rails are powered by a direct power connection using a terminal block connector, a PoE
switch, or a PoE injector.
Important:
Only use adequately protected power cables (min. Ø = 3 x 1.0 mm²).
The required power cable must meet the country's standards.
Only qualified personnel is allowed to perform work on the power cable!
Important:
Use the USB port for updates only. Do not connect any peripheral devices (for example, mouse, keyboard).
Each 3pin DMX512-A Out can be individually configured as DMX In.
DMX: The maximum length of the cable is 350 m (in ideal conditions).
Use CAT-5e Ethernet cable or higher. Max. length of the cable 75 m.
To Next Page
Loading...
