MA LIGHTCOMMANDER II 24/6 - Dimmer Curve; Swop Disable

Lightcommander 24/6 - 48/6Lightcommander 24/6 - 48/6
Lightcommander 24/6 - 48/6Lightcommander 24/6 - 48/6
Lightcommander 24/6 - 48/6
eMail: info@malighting.de
.
Tel.: +49 931 497940
.
User's Manual Lightcommander 24/6 - 48/6
3535
3535
35
UTILITY/
SETUP
CURVE
C U R V E
7.1.3 Dimmer Curve
Standard dimmerpacks usually show an non-linear increase on brightness
when moving up the channel fader. By choosing a special non-linear
output modulation this effect can be compensated. Therefore all channels
which are supposed to control dimmer channels have to be set to
"CURVE" on the Lightcommanders setup menu.
LED OFF = LINEAR LED ON = CURVE
For all channels set to CURVE, the LED will lit up and the graphics show a
bar upward. Changes can be done via the channel buttons.
Color scrollers and effects should be controlled with LINEAR setting.
AUX 1-6
channel
25-48
channel
1-24
7.1.4 Swop Disable
When using the SWOP effect (see 1.2), channels which control color
scrollers or effects should not be set to zero. For these channels the Swop
effect can be disabled.
UTILITY/
SETUP
SWOP
DISABLE
S W O P - D I S A B L E
ALL
ENABLED
ALL
DISABLED
LED OFF = ENABLED LED ON = DISABLED
On channels which are protected against the Swop effect the LED is on
and the graphic shows a bar upward. Changes can be done via the chan-
nel buttons.
ALL
LINEAR
ALL
CURVE
WIDE channels of the LC 48/6
OUTPUT
OUTPUT