12
12
PowerPool™
To clean the jet insert and housing, use a
pressurized hose and spray the inside of
the jet. Soak the jet in a diluted PowerPool™
cleaning solution, rinse. Wipe the inside of the
housing to remove any debris.
To reinstall the jet, line up the tab on the
backside of the barrel with the groove in the
body. Use the palm of your hand to gently tab
the jet until it snaps into position.
Air Controls
The intensity of the jet action can be
controlled by altering the amount of air
injected with water through the jets. Your
PowerPool™ has 2 to 4 air controls located
on the lip of the PowerPool™. Each control
activates air to specic jets in the PowerPool™
allowing you to create various combinations
and levels of jet action to suit individual
preferences. Turn the control counter-
clockwise to turn the air o and clockwise to
turn air on.
NOTE: Air controls should be closed
during heating cycles for maximum
energy eciency.
To Next Page
Loading...
