31
31
PowerPool™
Problem
Sanitizer
Dissipating
Too Rapidly
Usual Cause
- Excessive organics in
water
- Temperature too high
- Low pH
- Low pH corrodion of
metal xtures
- Low calcium hardness
- Low total alkalinity
Solution
- Increase shock dosage; add sanitizer;
shower before entering PowerPool™
- Reduce temperature
- Raise pH with sodium bicarbonate product
- Use chelating agent if metals are present;
* Keep proper pH level (7.2 to 7.6).
* Maintain minimum 150-200 ppm calcium
hardness
* Maintain proper alkalinity for type of
sanitizer used.
NOTE: If your source water has a high metal or mineral content, a specialty chemical should
be used to avoid staining or accumulation of deposits. These guidelines cover the most
common water problems when operating a PowerPool™ with ozone. Contact your dealer for
further information regarding chemical control issues.
To Next Page
Loading...
