28
Panel Unlock
To unlock the panel, touch the TIME, JETS1,
and SET DOWN buttons within 3 seconds. The “PL”
indicator light will go out when the panel lock is
cleared.
Operating Modes
Your Spa comes with three primary operating modes.
Standard Mode
maintains the water at the
desired set temperature. Note that the last measured
spa temperature displayed is current only when the
pump has been running for at least 2 minutes. The
“STANDARD” icon will be displayed in the LCD
window when this mode is selected.
Economy Mode
heats the water to the desired set
temperature ONLY during filter cycles. The
“ECONOMY” icon will be displayed in the LCD
window when this mode is selected. While in the
Economy mode, pressing the
JETS1
button will put
the spa into the
Standard-In-Economy
mode, which
operates the same as the Standard Mode, then reverts
back to the Economy mode after 1 hour. The spa can
be immediately reverted back into the Economy mode
at any time by simply pressing the
MODE/PROG
button.
Sleep Mode
heats the spa to within 20°F (11oC)
of the set temperature only during filter cycles. The
“SLEEP” icon will be displayed in the LCD window
when this mode is selected.
Changing Modes
To change the operating mode, press the
MODE/PROG
button. The operating mode will be
flashing on the LCD window. Press the
SET DOWN
button to cycle through to the desired mode, and then
press the
MODE/PROG
button to confirm selection.
Pressing
SET UP
or
SET DOWN
then
JETS2
will put the spa into the
Standby Mode
. While in this
mode, all spa functions are temporarily suspended to
allow for filter changes or other routine maintenance
tasks. Press any button to exit the Standby mode.
Time and Filtration Cycles
The control system on your spa has been designed
to function properly and safely at 100°F after
connecting the electrical wires and installing the
proper grounds. To take full advantage of the unique
capabilities of your new spa, you should first set the
time and establish your filtration cycles.
Setting the Time
When the time of day has not been programmed,
the “TIME” icon will be flashing on the LCD window.
To set the time of day, first press the
TIME
button
then press the
MODE/PROG
button. The hour
digit(s) will be flashing on the LCD window. Press
the
SET UP
or
SET DOWN
button to advance the
hours up or down to the desired set point. Press the
MODE/PROG
button to enter the time hour.
The minute digits will now be flashing on the
LCD window. Press the
SET UP
or
SET DOWN
button to advance the minutes up or down to the
desired set point. Press the
MODE/PROG
button to
enter the time minutes.
At this point you can either proceed with setting
the filtration cycles as described in the following
“Changing Filter Cycle” section, or press the
TIME
button to save the settings and exit the programming
sequence.
Preset Filter Cycles
Once the time of day has been set, your spa
will automatically filter the water for a 2-hour period
every 12 hours. The first filter cycle comes preset to
operate from 8:00AM to 10:00AM, and the second
filter cycle comes preset to operate from 8:00PM to
10:00PM. The F1 indicator light will be lit whenever
the spa is in the first filter cycle. The F2 indicator
light will be lit whenever the spa is in the second filter
cycle. During a filter cycle, the primary filtration
pump will operate in low speed and can not be turned
off unless the spa is put into the Standby mode. At the
beginning of each filtration cycle, the other equipment
in the spa will turn on for 30 seconds to purge all
plumbing lines and ensure complete filtration.
To Next Page
Loading...
Need help?
General
