76
note: It’s important that once you have completed the above steps you make
sure that the water cylinder is correctly installed to prevent water freezing in the
cylinder’s interior.
caution: Only ll with drinking water.
removal of ice
After a while, your ice cubes will be ready 1.
for use. To remove them, pull the handle
slowly towards you until it’s fully down.
At this point it will be necessary to pull the
handle a little more forcefully until you hear
the ice fall into the lower compartment of
your Smart Fill Ice Factory.
This compartment can hold up 3 complete 2.
releases of the ice-tray. To remove the ice,
simply lift and pull the storage box that
you will nd in the lower part. This box is
designed to be brought wherever you wish.
To make more ice, repeat the process.
note: The cylinder can only hold one load at a
time. Before repeating the process, make sure
that the tray is empty.
note: The ice produced may vary in size.
cleaning the smart fill ice factory
When cleaning your Smart Fill Ice Factory it is imperative that you only use a
soft sponge with water and a neutral soap. Afterwards, leave it to dry.
DO NOT use a steel wool sponge or detergent to clean the SFIF (specially the
ice-bucket), as this could aect how it works, change how it looks, and aect
the avour of your ice cubes.
cleaning the cylinder
Only use a soft sponge with water and a neutral soap to clean. Afterwards, leave it
to dry. Don’t use steel wool sponges or detergents, knives or forks as these could
scratch or damage the central valve. If there’s frozen water inside the cylinder, let
it melt or use tepid water to speed up the process.
important: When removing the ice cubes, pull the
handle all the way down. You will feel resistance at
this point, but you need to pull a little more so that
the ice-tray twists and releases the ice into the lower
compartment. Once this point has been reached, the
process is complete.
To Next Page
Loading...
