87
water dispenser
(only available with certain models)
manually. You can obtain cold water from the outside of the refrigerator, saving
energy use.
how to start
once every 30 days never employing the use of detergents or odorous cleaning
products. The tank has a lock (
*
) on the back that guarantees its position and
ensures water is dispensed correctly.
removing the tank:
Turn the lock clockwise.1.
Hold the tank from the sides and lift.2.
Pull towards you to remove completely.3.
putting the tank back:
Lock’s position must be as shown (1.
*
)
(make sure it is turned to the left)
Hold the tank from the sides and slide 2.
the nozzle into the corresponding
opening on the door.
Push the tank -while lifting slightly- and make sure the side tabs are 3.
correctly mounted on the door.
Turn the lock to the right (while holding the back side of the tank)
note: You will see a thin space between the shelf and the door cover, but
this is normal.
note:
system. It is important to put it back in a correct way. Seal tabs must be inside
of the inner tank wall as shown in the image so that it avoids spills.
important:
Read the instructions before using.•
The dispenser should only be used with pure drinking water. If it is used •
with liquid tany other he manufacturer is not responsible for any damage
caused.
Remember to clean the inside of your refrigerator with a cloth or soft •
sponge, and a neutral soap.
4
2
3A
1
3B
*
22
1
*
3
To Next Page
Loading...
