88
filling the water cylinder
To pour the water in, lift the lid, add only 1.
natural drinking water using a glass or jug
until the liquid reaches the level marked
on the cylinder.
Replace the top, putting pressure on it.2.
using the water dispenser:
Push the dispensing ap backwards with 1.
a glass until water comes out. Release
the ap. Keep the glass in place until the
water ow stops completely.
Always hold on to the glass while serving 2.
water.
In the case of an accidental water spillage; 3.
slide the droplet-collecting grille forwards,
throw out the water, and replace the grille
by sliding it back in.
The capacity of the water tank depends on the model of your refrigerator.
19ft (510 Lts) = 3 liters of water
15ft (400 Lts) = 2 liters of water
* To verify the water tank capacity look on the labels inside your refrigerator.
cautions for use:
To avoid water overowing, do not ll the container to the top. The maximum t
water level is marked on the cylinder.
If the water container has not been properly positioned, water could escape and t
won’t be released through the dispenser.
If the dispenser is not used regularly, water may have an odd taste when it’s t
subsequently used.
Don’t remove any parts of the dispenser except for the cylinder, its top, and the t
grille which collects droplets.
After serving water, it is normal for a few droplets to fall. You can minimise this t
by removing the glass slowly from the dispenser. At other times, due to the
formation of light condensation, droplets may fall.
important: Do not pour water until the
tank is properly placed on the door.
importante:
Do not ll the container all the way to the
top to avoid overowing.
Always hold the glass while serving
water.
Don’t remove dispenser parts.
To Next Page
Loading...
