Mac allister MBC3630 - Page 35

EN
35
In
more
detail...
MBC3630
by MacAllister
Operation
Tips
6. Ensure the cutting device remains clean and free from off-cuts that may cause
it to jam. Check regularly. Release the on/off switch (1) and disconnect the
product from the power supply before checking.
7. Trim longer grass in stages; do not cut long grass in one cut (Fig. 24). For the
best results, cut longer grass in steps (Fig. 25).
Fig. 24 Fig. 25
Fig. 26
1. For best results, do not cut wet grass because it
tends to stick to the cutting head and guard, prevents
proper discharge of grass trimmings, and could
cause you to slip and fall.
2. Do not allow the spool cover to drag on the ground or
other surfaces.
3. Pay special attention when performing the work close
to trees and bushes. The cutting head could damage
sensitive bark, and damage fence posts (Fig. 26).
Fig. 24 Fig. 25
Fig. 26
NOTE:
The trimming line will wear faster and require more
replacement if cutting is done along sidewalks or other abrasive
surfaces or heavier weeds are being cut.
NOTE:
While trimming, the cutting device is possible to be blocked by
grass or unevenly ground. So the product will turn off automatically
due to over current. Therefore release the on/off switch for over 3s
and then press down again to go on with trimming.