Mac allister MLM1334 - Page 15

EN
15
Getting
started...
MLM1334
by MacAllister
7. Do it again on the other side. Make sure that the interconnection cord (16) run
on the upper side of the handle bars (5, 7).
8. Secure the inter-connection cord (16) with two wire clips (17) (Fig. 4). Pull
the inter-connection cord (16) to avoid contact with the rear wheel (10) if
necessary.
5
2
6b
16
6a
6
6
6a
7
1.
2.
3.
3.
2.
Fig. 3
17
16
10
Fig. 4
NOTE:
There are two handle height positions in the upper handle bar
(5). Ensure the upper handle bar (5) is assembled on the same height
level on both lower handle bars (7).
Before you start