Mac allister MLM1841 - Page 25

EN
25
In
more
detail...
MLM1841
by MacAllister
1. Make sure that the lawn is clear of stones, sticks, wire or other objects that
could damage the product or its product.
2. Do not cut wet grass because it tends to stick to the underbody of the
product, preventing the proper discharge of grass clippings, and it could also
cause you to slip and fall.
3. Never cut off more than one-third of the total length of the grass for a healthy
lawn. In the autumn, lawns should only be cut as long as there is growth.
4. Slowly push the product forward.
5. Mow in slight overlapping rows. The most effective pattern for mowing lawns
is straight lines along one of the sides. This will keep the rows even and
ensures that all the lawn is cut without missing any spots (Fig. 17).
6. Circle around ower beds. When reaching a ower bed in the middle of the
lawn, cut a row or two around the circumference of the bed.
Mowing
Operation
Ensure the extension cord is well hooked on the cord retainer (2a). Connect the
plug to the power supply via the extension cord.
1. Stand behind the grip handle (2).
2. While holding the safety switch button (1) pressed (Fig. 16, step 1), pull the
start levers (3) towards the grip handle (2) (Fig. 16, step 2).
3. After the mower starts, release the safety switch button (1).
4. The product starts moving forward and begins mowing.
5. Release the start levers (3) to stop the mower.
1 22a
3 3
2. 2.
1.
Fig. 16
Fig. 17
Fig. 17
1 22a
3 3
2. 2.
1.
Fig. 16
Fig. 17
Fig. 16