EN
24
In
more
detail...
MLM1841
by MacAllister
Starting/Stopping
WARNING!
Before starting, put the product on a at surface free of
high grass! Clean the underside of the deck!
Start the motor carefully according to instructions. Keep your feet well
away from the cutting blade (13c)!
Do not tilt the product when starting the motor.
1. Check the product as well as accessories for damage before each use. Do
not use the product if it is damaged or shows wear. Take care of any problem
you nd or have the product checked by qualied specialist.
2. Double check that accessories or attachments are properly xed.
3. Always push the product using the grip handle (2). Keep the handles dry to
ensure safe support.
4. Ensure that the air vents are always unobstructed and clear. Clean them if
necessary with a soft brush. Blocked air vents may lead to overheating and
damage the product.
5. Switch the product off immediately if you are disturbed while working by other
people entering the working area. Always let the product come to complete
stop before putting it down.
6. Do not overwork yourself. Take regular breaks to ensure you can concentrate
on the work and have full control over the product.
Operation
Starting / stopping
General operation
NOTE:
The product can only be started by pressing the safety
switch button (1) followed by squeezing the start levers (3). Reverse
operation cannot start the product.
To Next Page
Loading...
