What to do if MAC3 Inverter shows Cortocircuito Short Circuit?
If the MAC3 Inverter displays a short circuit error, this indicates a detected short circuit between phases. To resolve this, identify the location of the short circuit, check the pump's current consumption, and then disconnect the voltage. Wait for the display to turn off before reconnecting.
What to do if MAC3 E-Power e-MM08 Inverter shows Falta de Agua Dry running?
If the MAC3 Inverter indicates a 'Dry running' error, it means a lack of water has been detected. First, ensure there is a water supply. Then, reset the pump priming function. Check the filter for blockages. Disconnect the power, wait for the display to switch off, and then reconnect the power supply.
What to do if MAC3 Inverter shows Sobrecorriente Detectada en la bomba?
If the MAC3 Inverter displays 'Sobrecorriente Detectada en la bomba', check the 'LoadCurrent' output to verify the current measurement. Set the correct maximum current value and ensure the pump operates within the manufacturer's specified conditions, checking for friction or locking.
How to unlock MAC3 E-Power e-MM08 after Short Circ.Block error?
If the MAC3 Inverter is in a locked state due to repeated short circuit errors, reset the lock status by setting parameter 65 'Tot.ShortC.Done' to zero. If the problem continues, try resetting the drive by unplugging the pump.
What to do if MAC3 E-Power e-MM08 Inverter indicates Presión insuficiente. Insuff. Pres?
If the MAC3 Inverter shows 'Presión Insuficiente', it means the measured pressure is below the set minimum (default 0.8 bar). Check the system for significant leaks and verify the electro-pump dimensions are correct. After addressing these potential issues, disconnect the power, wait for the display to switch off, and then restore power.
What causes Alto voltaje High voltage error on MAC3 Inverter?
If the MAC3 Inverter indicates 'High voltage', it means the measured power voltage is above 270 Vac. Inspect the wiring system and adjust the values to remain within the EPOWER range. Also, check for air inside the pump and eliminate it if necessary.
What causes Bajo voltaje Low Voltage on MAC3 E-Power e-MM08?
If the MAC3 Inverter displays 'Low Voltage', the measured power voltage is below 160 Vac. Check the electrical system and adjust the values to be within the EPOWER's specified range.
What to do if MAC3 E-Power e-MM08 Inverter shows Alta temperatura del líquido High Temp. error?
If the MAC3 Inverter displays 'Alta temperatura del líquido High Temp', the internal temperature is above 75°C. Verify the water temperature is within the product specifications and ensure the pump priming action is correct.
What to do for Golpe de ariete Water Hammer on MAC3 E-Power e-MM08?
If the MAC3 Inverter detects a 'Golpe de ariete' (Water Hammer), the system has registered a pressure overrun more than twice the set pressure. Check the expansion tank to ensure it is functioning correctly.
Why MAC3 E-Power e-MM08 Inverter shows Protección bomba Pump Protection?
If the MAC3 Inverter activates 'Pump Protection', it means the pump has been running continuously for the duration set in parameter 40. Inspect the system for leaks.
To Next Page
General
