41
MCS2400 by MacAllister
In more detail...
GB
IE
Maintain a rm grip, with thumbs and ngers encircling the >
chain saw handles, with both hands on the saw and position
your body and arm to allow you to resist kickback forces.
Kickback forces can be controlled by the operator, if proper
precautions are taken. Do not let go of the chain saw.
Do not overreach and do not cut above shoulder height. >
This helps prevent unintended tip contact and enables better
control of the chain saw in unexpected situations.
Only use replacement bars and chains specied by the >
manufacturer. Incorrect replacement bars and chains may
cause chain breakage and/or kickback.
Follow the manufacturer’s sharpening and maintenance >
instructions for the saw chain. Decreasing the depth gauge
height can lead to increased kickback.
Additional safety warnings
The product should be supplied via a residual current device >
(RCD) with a tripping current of not more than 30 mA.
Position the cord so that it will not be caught on branches and >
the like, during cutting.
It is recommended that rst-time user should, as a minimum >
practice, cutting logs on a saw-horse or cradle.
Clothing and protective equipment
Do secure long hair so that it is above shoulder level. >
Do not wear loose tting clothing or jewellery as this could be >
drawn into the engine, catch the chain or undergrowth.
Use the following safety clothing and protective equipment when >
operating the product:
Helmet with visor and neck guard - (EN397 compliant),•
Hearing protectors,•
Breathing mask,•
Gloves with approved saw protection (compliant to EN 381-•
4, EN 381-7, EN420:1, EN 388 Class 0),
Protective leggings with approved saw protection (compliant •
to EN 381-5, EN 340 Class 1),
Steel toe cap boots with approved saw protection (compliant •
to EN 345-2 Class 2),
First Aid kit in case of injury.•
Technical and legal information
To Next Page
Loading...
