42
MCS2400 by MacAllister
In more detail...
GB
IE
Technical and legal information
Safety warnings
Vibration and noise reduction
To reduce the impact of noise and vibration emission, limit the time
of operation, use low-vibration and low-noise operating modes as
well as wear personal protective equipment.
Take the following points into account to minimize the vibration and
noise exposure risks:
Only use the product as intended by its design and these >
instructions.
Ensure that the product is in good condition and well >
maintained.
Use correct application tools for the product and ensure they in >
good condition.
Keep tight grip on the handles/grip surface. >
Maintain this product in accordance with these instructions and >
keep it well lubricated (where appropriate).
Plan your work schedule to spread any high vibration tool use >
across a number of days.
Emergency
Familiarise yourself with the use of this product by means of
this instruction manual. Memorise the safety directions and
follow them to the letter. This will help to prevent risks and
hazards.
Always be alert when using this product, so that you can >
recognise and handle risks early. Fast intervention can
prevent serious injury and damage to property.
Switch off and disconnect from the power supply if there >
is any malfunction. Have the product checked by a qualied
specialist and repaired, if necessary, before you put it into
operation again.
Residual risks
Even if you are operating this product in accordance with all
the safety requirements, potential risks of injury and damage
remain. The following dangers can arise in connection with the
structure and design of this product:
Health defects resulting from vibration emission if the product is >
being used over long periods of time or not adequately managed
and properly maintained.
To Next Page
Loading...
