MacAllister MTC650 - Fitting the Cutting Disc Components

Fig. 3
Fig. 4 Fig. 4-1
> Place cutting disc (2) on inner flange (24).
> Attach the outer flange (22).
> Screw hexagon nut (21) onto motor shaft (25) clockwise.
> Attach the straight spanner (20) to the hexagon nut (21).
> Lock motor shaft (25) to prevent turning using angle spanner (23).
> Tighten hexagon nut (21) clockwise using straight spanner (20).
> Re-attach the lower protective guard (17) and tighten cross-screws (19).
> Replace the vertical fence (3).
14
MTC650 by MacAllister
Before you start
Getting started...
25
25
22
21
25
2
2
22
21
23
20
22
23
24
22
24
25
20
EN