MacAllister MTC650 - Mitre Cutting Guide Setup

Fig. 10
19
NOTE: The mitre cutting guide can be set to a desired angle (0°~
45°). The mitre cutting guide can only be used when the parallel
cutting guide is mounted.
Mounting/setting the mitre cutting
guide
Before you start
MTC650 by MacAllister
Getting started...
> Place mitre cutting guide (10) on parallel cutting guide (11).
> Loosen locking knob (12).
> Set mitre cutting guide (10) at desired angle.
> Tighten locking knob (12).
NOTE: The vertical fence can be set to a desired angle (0°,15°,
30° or 45°).
Setting product for jolly cuts
> Raise the vertical fence (3) approx. 45°.
> Fold out the holder (35) and set to the desired angle in the locators (36).
> Ensure that the vertical fence (3) is correctly secured before working.
11
10
12
EN