MacAllister MTC650 - Page 30

Fig. 18
Fig. 19
30
MTC650 by MacAllister
Care and maintenance
In more detail…
> Attach the straight spanner (20) to the hexagon nut (21).
> Lock motor shaft (25) to prevent turning using angle spanner (23).
> Loosen hexagon nut anti-clockwise using straight spanner (20).
> Remove the hexagon nut and outer flange (22).
> Remove the cutting disc (2) from inner flange.
> Thoroughly clean outer flange, inner flange and motor shaft.
Fitting the cutting disc: (Refer to “Fitting the cutting disc” section on Page. 11-13)
> Loosen cross-screws (19) and pull off lower protective guard (17).
19
17
23
20
22
25
2
EN