MacAllister MWDV20L - Troubleshooting and Disposal; Troubleshooting Common Issues; Recycling and Disposal Advice

EN
PROBLEM POSSIBLE CAUSES SOLUTIONS
Missing Parts/Accessories 1. They are wrapped up in 1. Check the tank.
the tank.
The vacuum cleaner does 1. No power at the outlet. 1. Check the power.
not start 2. Not plugged in correctly. 2. Unplug/insert the plug
into the outlet again.
3. The power cord is cut. 3. Have it replaced by an
Authorised Customer
Service Center.
4. On/Off switch defective. 4. Have it repaired by an
Authorised Customer
Service Center.
5. Defective Motor. 5. Have it repaired by an
Authorised Customer
Service Center.
Dust coming out of the 1. The lter is not installed 1. Install the lter correctly.
exhaust port or not installed correctly.
2. The lter is damaged. 2. Replace the lter.
3. The lter is clogged or 3. Use a more efcient lter.
the dust is too ne.
4. The lter doesn’t work. 4. Clean or replace the lter.
Loss of suction 1. The exible hose tting 1. Tighten the tting.
is loose.
2. Filter clogged. 2. Clean or replace the lter.
3. Tank or bag full. 3. Empty or replace them.
4. Hole in the hose. 4. Replace the hose.
5. Hose or accessory 5. Check and unclog as
clogged. necessary.
Static Shock 1. Dry environment. 1. Increase humidity. (Where
possible, use a portable or
stationary humidier.)
2. Air’s relative humidity 2. This is temporary and does
too low. not affect the use of
the vacuum cleaner.
Mist in exhaust air 1. The lter is saturated. 1. Clean or replace the lter.
11
Recycling and disposal
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local Authority or local store for recycling
advice.
> The product comes in a packaging that protects it against transportation damage.
Keep hold of the packaging until you are sure that all the parts have been delivered and the
product is functioning properly. Recycle the packaging afterwards.
Troubleshooting