To Next PageTo Next Page
Need help?Do you have a question about the Mackie SP260 and is the answer not in the manual?
General| Sampling Rate | 48 kHz |
|---|---|
| Bit Depth | 24-bit |
| Maximum Input Level | +22 dBu |
| EQ | Yes |
| Limiter | Yes |
| USB | No |
| Inputs | 2 |
| Analog Outputs | 6 |
| Outputs | 6 |
| Frequency Response | 20 Hz to 20 kHz |
| THD+N | <0.01% |
| Input Impedance | 10 kOhms |
| Output Impedance | 100 Ω |
Step-by-step guide to quickly set up the SP260 system.
Details the rear panel components, connectors, and power functions.
Details the front panel components, including display, buttons, LEDs, and meters.
Covers USB connectivity for PC control and the factory reset procedure.
Covers gain, delay, EQ bypass, and 5-band EQ for inputs.
Sets output channel names, input sources, polarity, and gain levels.
Covers 7-band EQ, High Pass, and Low Pass filters for outputs.
Details limiter settings and VU meter mode selection for outputs.
Addresses power issues, ground hum, and signal noise.
Helps resolve issues with no audio output or uneven volume.
Covers factory reset and procedures for obtaining product repair.
