Need help?Do you have a question about the Mackie THUMP 115 S and is the answer not in the manual?
General| Type | Powered Subwoofer |
|---|---|
| Polarity Switch | Yes |
| Enclosure Material | Wood |
| High-Pass Filter | Yes |
| Phase Switch | Yes |
| Driver Size | 15 inches |
| Input Connectors | 2 x XLR/TRS combo |
| Output Connectors | XLR |
Diagram showing a single Mackie Thump subwoofer connected to a PA system.
Diagram illustrating two Mackie Thump subwoofers connected to a PA system.
Details the IEC power connector for attaching the power cord.
Description of the power switch for turning the unit on/off and the front LED.
Explains the input connectors for line-level stereo or mono sources.
Details the output for connecting full-range main speakers.
Explains the output for connecting additional subwoofers.
Describes the gain knob for adjusting input sensitivity and overload indication.
Control for toggling the front panel LED on or off.
Switch to invert the phase for improved low-frequency clarity.
Selects stereo L/R or summed mono output for the full-range signal.
Mode selection for optimizing main speaker output with the subwoofer.
Read safety instructions, power off all equipment, connect cables, set controls, and power on devices sequentially.
Details the frequency response range and maximum SPL for THUMP115S and THUMP118S.
Information on total system power, driver size, and amplifier class.
Specifies connector types, power input voltage, and consumption.
Details protection features, unit dimensions, and weight.
To Next Page
