Cutting capacity(0°) mm 75
Cutting capacity(45°) mm
60
4.Safety
4.1 Specified conditions of use
This machine is intended to rip and crosscut grown
timber,faced boards,chip board and wood-core
plywood sheets,and similar wood-derived materials.
Do not cut round stock without suitable jigs or
fixtures.The rotating saw blade could turn the
work-piece.When sawing thin stock layed on edge,
a suitable guide must be used for firm support.
Use of wobble saw blades is not permitted on
this machine.
Danger! Any other use is not as specified.
Use not as specified, alteration of the electric tool
or use of parts that are not approved by the
equipment manufacturer can cause unforeseeable
damage!
4.2General safety instructions
1. Keep work area clear
– Cluttered areas and benches invite injuries.
2. Consider work area environment
– Do not expose tools rain.
– Do not use tools in damp or wet locations.
– Keep work area well lit.
–
Do not use tools in the presence of
flammable liquids of gases.
3. Guard against electric shock
– Avoid body contact with earhted or grouneded
surfaces.(e.g.pipes,radiators,ranges,refrigerators).
4. Keep other persons away,
– Do not let persons,especially children,not involved
in the work touch the tool or the extension cord
and keep them away from the work area.
5. Store idle tools
– When not in use,tools should be stored in a dry
locked up place,Out of reach of children,
–
6. Do not force the tool
– It will do the job better and safer at the rate for
when it was intended.
–
7. Use the right tool
– Do not force small tools to do the job of a heavy
duty tool.
– Do not use tools for purposes not intended; for
example do not use circular saws to cut tree limbs
or legs.
8. Dress properly
– Do not wear loose clothing or jewellery,they can
be caught in moving parts.
– Non-skid footwear is recommended when working
outdoors,
– Wear protective hair covering to contain long hair,
9. Use protective equipment
– Use safety glasses.
– Use face or dust mask if working operations create
dust.
10. Connect dust extraction equipment
– If the tool is provided for the connection of dust
extraction and collecting equipment,ensure these
are connected and properly used.
11. Do not abuse the cord
– Never yank the cord to disconnect it from the
socket. Keep the cord away from heat,oil and
sharp edges.
12. Secure work
– Where possible use clamps or a vice to hold the
work. It is safer than using your hand.
13. Do not overreach
– Keep proper footing and balance at all times.
To Next Page
Loading...