DESCRIPTION
SAFETY MANUAL included with unit.
Read before operating and keep for
future reference to learn proper, saf e
operating techniques.
1. BLADE Circular blade for grass, weed or
brush cutting applications. Harness, metal
shield and U‐Handles required for blade
operation.
2. DRIVE SHAFT ASSEMBLY Contains a
specially designed liner flexible drive
shaft.
3. THROTTLE TRIGGER Spring loaded to
return to idle when released. When
accelerating, press trigger gradually for
best operating technique. Do not hold
trigger while starting.
4. IGNITION SWITCH" slide switch
mounted on top o
the Throttle Trigger
Housing. Move switch FORWARD to Run
back to STOP.
5.SAFETY LEVER Before acceleration,
compress it please.
1.U‐HANDLE this handle can be adjusted
at you conve nience for comfort.
2.HARNESS ASS'Y a attachment which
hang the machine on the operator and
adjustable in length.
3.AIR CLEANER COVER Contains
replaceable felt element.
4.FUEL TANK LID.
5.FUEL TANK Contains fuel and fuel filter.
11.PURGE BULB Pushing purge lulb(7 to 10 times
before staring),will remove all air and stale fuel from
fuel system and bring fresh fuel to the carburetor.
12. CHOKE the choke control is located on the top of
the filter cover.
COLD STARTS ‐ Pull lever up to close choke for cold
starts. Push lever down for RUN position.
13. DEBRIS SHIELD Mounted just above the cutting
attachment. Helps protect operator by deflecting
debris produced during the trimming operation. Do
not operate unit without shield.
14. CUT‐OFF KNIFE Trims nylon filament to the
correct length‐7", head to end of line‐when nylon
trimming head is bumped on the ground during
operation, line advance. If trimmer is operated
without a cut‐off knife the line becomes too long
(more than 7") the operating speed will slow down
the engine, this will overheat or damage the engine.
15. NYLON CUTTER HEAD Contains replaceable
nylon trimming line that advances when the
trimmer head is tapped against the ground while
the head is turning at normal operating speed.
To Next Page
Loading...