HANDLING
STARTING CHECK
94 Operating Manual MT 25 / 30 YT
WARNING!
Accident hazard!
If you leave the MT while the motor is running, the MT
can start rolling unintentionally and seriously injure
persons.
X Always shift into neutral N before exiting the MT and
apply the parking brake.
X Make sure the engine is running at low idle speed
(500 to 800 rpm).
X Secure the wheels additionally with blocks.
Oil level check with oil dip stick (hot check)
The oil dip stick is located under the transmission cover right
on the transmission.
Fig. 89: Oil dip stick
X
Make sure that the oil has reached the normal operating
temperature between 60 °C and 93 °C.
The operation temperature can be read from the tempera-
ture indicator in the multi-function display.
The operational temperature is reached when the transmis-
sion has run under load for at least one hour.
X Park the MT on level ground for the oil level check.
X Shift the transmission into neutral N and apply the parking
brake.
X Let the engine run at low idle speed (500 to 800 rpm).
Fig. 90: Oil dip stick
1 Oil filler nozzle
2 Oil dip stick
3 HOT CHECK range
X
Pull the oil dip stick out.
X Wipe the oil dip stick with a clean, lint-free cloth.
X Reinsert the dip stick completely.
X Pull the oil dip stick out again.
X If necessary, refill oil into the oil filler nozzle or drain oil.
The oil level should lie in the “HOT CHECK” range between
the “HOT-ADD” and “HOT-FULL” markings.
To Next Page
Loading...
