HANDLING
STARTING CHECK
Operating Manual MT 25 / 30 YT 97
In case of an error at the sensor, check the oil level
with the oil dip stick. In case the oil level is correct, but
the error at the sensor “oL FL” is still displayed, contact
customer service to rectify the fault.
Ending the oil level check
X Press both arrow keys 1 and 2 until “N - N” is displayed in
the display.
Fuel supply
Check the fuel supply level before you drive the MT. It is indi-
cated in the LCD display of the multi-function display.
Refuel when the fuel level is low, see “Refuelling” on page 106.
Oil level sensor
error
Cause
oL 0X Settling time too short Setting time too
oL EL Engine speed Low Motor speed too low
oL EH Engine speed High Motor speed too high
oL SN Select Neutral Not in neutral
oL TL Temperature Low Oil temperature too low
oL TH Temperature High Oil temperature too high
oL SH Outputspeed High Drive shaft is turning
(MT is moving)
oL FL Sensor Failure Error at the sensor
To Next Page
Loading...
