MAG TOOLS MCF894 - Date Code Position; Trigger Switch; Package Contents; Battery Type

7
ENGLISH
the latest regulations for packaging, labeling/marking and
documentationrequirements.
The information provided in this section of the manual is
provided in good faith and believed to be accurate at the time
the document was created. However, no warranty, expressed or
implied, is given. It is the buyer’s responsibility to ensure that its
activities comply with the applicableregulations.
Storage Recommendations
1. The best storage place is one that is cool and dry away
from direct sunlight and excess heat or cold. For optimum
battery performance and life, store battery packs at room
temperature when not inuse.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool, dry place out of the charger for
optimalresults.
NOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be recharged
beforeuse.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the labels
on the charger and the battery pack may show the following
pictographs:
Read instruction manual beforeuse.
See Technical Data for chargingtime.
Do not probe with conductiveobjects.
Do not charge damaged batterypacks.
Do not expose towater.
Have defective cords replacedimmediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indooruse.
Discard the battery pack with due care for
theenvironment.
Charge Mac Tools battery packs only with
designated Mac Tools chargers. Charging battery
packs other than the designated Mac Tools batteries
with a Mac Tools charger may make them burst or
lead to other dangeroussituations.
Do not incinerate the batterypack.
Battery Type
The MCF894 operates on a 18 volt batterypack.
These battery packs may be used: MB183 and MB184 .
Refer to
Technical Data for moreinformation.
Package Contents
The package contains:
1 Impact wrench
1 Charger (P2 models)
1 Kitbox ( P2 models)
2 Li-Ion battery packs ( P2 models)
1 Instruction manual
NOTE: Battery packs, chargers and kitboxes are not included
with Nmodels.
• Check for damage to the tool, parts or accessories which may
have occurred duringtransport.
• Take the time to thoroughly read and understand this manual
prior tooperation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual beforeuse.
Wear earprotection.
Wear eyeprotection.
Visible radiation. Do not stare intolight.
Date Code Position
The date code, which also includes the year of manufacture, is
printed into thehousing.
Example:
2017 XX XX
Year of Manufacture
Description (Fig. A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury couldresult.
1
Trigger switch
2
Forward/reverse control button
3
Anvil
4
Main handle
5
Battery release button
6
Battery pack
7
Worklight
8
Mode selector
9
Hog ring