PROBLEM
Oven will not seif-cieano
Oven did not
clean properiyo
Oven door will not unlock
after self=clean cycle.
Smoothtop surface
shows wear.
Moisture collects on oven
window or steam comes
from oven vent.
There is a strong odor
or light smoke when
oven is turned on.
Fault Codes
Noises may be heard.
There are no beeps and
"SAb" flashing and then
dispJayed continuousiyo
, Check to make sure the cycle is not set for a ddayed start. See page 16=
° Check if door is dosed.
, Check if controi is in Sabbath Mode. See page 13.
, Oven may be over a00° R Oven temperature must be bdow a00° F to program a dean cycle.
, Longer cleaning time may be needed.
, Excessivespillovers, especially sugary and/or acidic foods, were not removed prior to the
self-dean cycle.
, Oven interior is still hot. Allow about one hour for the oven to cool after the compbtion of
self-dean cycle. The door can be opened when the LOCK indicator word is not displayed.
° The control and door may be locked. See pages 9 and 17 to unlock.
1.Tiny scratches or abrasions.
, Make sure cooktop and pan bottom are clean. Do not slide glass or metal pans across top.
Make sum pan bottom is not rough. Use the recommended cleaning agents. See page 18.
2.Metal marks.
, Do not slide metal pans across top. When cool, clean with Cooktop Cleaning Creme.
See page 18.
3. Brown streaks and specks.
, Removespills promptly. Never wipe with a soiled cloth or sponge. Make sure cooktop and
pan bottom are clean.
4.Areas with a metallic sheen.
, Mineral deposits from water and food. Use recommended cleaning agents. See page 18.
5. Pitting or flaking.
, Removesugary boilovers promptly. See page 18.
° This is normal when cooking foods high in moisture.
° Excessive moisture was used when cleaning the window.
° This is normal for a new range and wii[ disappear after a few uses. Initiating a dean cycle
will "burn off" the odors more quickly.
° Turning on a ventilation fan will help remove the smoke and/or odor.
° Excessivefood soils on the oven bottom. Use a self-clean cycle.
, BAKE or LOCK may flash rapidly in the display to alert you if there is an error or a problem.
If BAKE or LOCK appear in the display, press CANCEL pad. If BAKE or LOCK continue to
flash, disconnect power to the appliance. Wait a few minutes, and then reconnect power.
Ifthe flashing still continues, disconnect power to theappliance and callan authorized servicer.
, Ifthe oven is heavily soiled, excessivefiareups may result in a fault code during cleaning. Press
the CANCEL pad and allow the oven to cool completely, wipe out excess soil, then reset the
clean cycle. If the fault code reappears, contact an authorized servicer.
, The oven makes several low level noises. You may hear the oven relays as they go on and off.
This is normal.
, As the oven heats and cools, you may hear sounds of metal parts expanding and contracting.
This is normal and wiii not damage your appliance.
, Oven may be in Sabbath Mode. See page 13.
° Oven is in Sabbath Mode. To cancel, press and hold the Ciock pad for five
seconds.
22
To Next Page
Loading...
