EN
CARE AND MAINTENANCE
Cleaning Your Appliance
• Upon installation of your new appliance, it is recommended that it be cleaned thoroughly.
• Turn the temperature control knob to “0” and then unplug the unit from the wall outlet.
• Remove all contents.
• Wash the inside with a damp warm cloth soaked in lukewarm water and baking soda solution.
The solution should be about 2 tablespoons of baking soda to a quart of water.
• Be sure to keep the door gasket (seal) clean to keep the unit running efficiently.
• The outside of the beverage cooler should be cleaned with mild detergent and warm water.
• Dry the interior and exterior with a soft cloth.
Vacation Time
• Turn the temperature control knob to “0” and then unplug the unit from the wall outlet.
• Remove all the contents.
• Clean the appliance.
• Leave the lid open slightly to avoid possible formation of condensation, mold, or odors.
• Short vacations: Leave the beverage cooler operating during vacations of less than three weeks.
• Long vacations: If the beverage cooler will not be used for several months, remove all content and
unplug the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth,
leave the door open slightly: blocking it open if necessary.
Moving Your Appliance
• Turn the temperature control knob to “0” and then unplug the unit from the wall outlet.
• Remove all the contents.
• Securely tape down all loose items inside your appliance.
• Tape the doors shut.
Energy Saving Tips
• The beverage cooler should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
• Ensure that door is properly closed when the beverage cooler is turned on.
To Next Page
Loading...
Need help?
General
